Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER AIRBAG SENSOR ASSEMBLY

CENTER AIRBAG SENSOR ASSEMBLY > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.



3. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



4. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
  1. Separate the front door opening trim weatherstrip LH.



5. REMOVE FRONT PILLAR GARNISH LH

HINT:
Use the same procedure for both sides.



6. REMOVE INSTRUMENT SIDE PANEL LH


    B192331E01
  1. Apply protective tape, as shown in the illustration.

  1. Using a moulding remover, disengage the 3 claws and 4 guides and remove the side panel.



7. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B192511
  1. Disengage the 3 claws.

  1. Disconnect the hood lock control cable and remove the hood lock control lever sub-assembly.



8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


B192333
  1. Remove the 2 <A> bolts.

  1. Disengage the 4 clips and claw.

  1. Disengage the 2 claws and separate the sensor.

  1. Disconnect the connectors and remove the finish panel.



9. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    B161741
  1. Twist the shift lever knob in the direction indicated by the arrow and remove it.



10. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


B161742
  1. Disengage the 12 clips and remove the console panel.



11. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY


B192328
  1. Move the shift lever to N.

  1. Remove the clip.

  1. Disengage the 6 clips and remove the console panel.

  1. Disconnect the connector



12. REMOVE REAR CONSOLE BOX POCKET


B188221
  1. Remove the rear console box pocket.



13. REMOVE CONSOLE BOX CARPET


B188222
  1. Remove the console box carpet.



14. REMOVE REAR CONSOLE BOX ASSEMBLY


B188223
  1. Disconnect the connectors.



    B192330
  1. Remove the 4 bolts and 2 screws.

  1. Disengage the 6 claws and remove the rear console box.



15. REMOVE FRONT CONSOLE BOX


B188224
  1. Disengage the 2 clamps.

  1. Remove the 2 clips.

  1. Remove the 5 screws and the front console box.



16. REMOVE AIRBAG SENSOR ASSEMBLY


B192367E01

CAUTION:
Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.

  1. Pull the lever down and detach the connector holder.



    B192369
  1. Remove the 3 bolts and remove the airbag sensor.