Home › Engine / Hybrid System ยท CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH

CRUISE CONTROL MAIN SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL CRUISE CONTROL MAIN SWITCH


    B160020E02
  1. Install the switch, as shown in the illustration.



    B160019E01
  1. Install the 2 screws.

  1. Connect the connector.



2. INSTALL STEERING PAD
  1. With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
    Cuts, small cracks or marked discoloration on the steering pad top surface or in the grooved portion.

  1. Check that the horn sounds.
    If the horn does not sound, inspect the horn system.



3. INSTALL LOWER NO. 3 STEERING WHEEL COVER


    B166432
  1. Attach the 2 claws to install the cover.



4. INSTALL LOWER NO. 2 STEERING WHEEL COVER


    B166433
  1. Attach the 2 claws to install the cover.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



6. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).