CRUISE CONTROL MAIN SWITCH > INSPECTION |
| 1. INSPECT CRUISE CONTROL MAIN SWITCH (w/o Dynamic Laser Cruise Control System) |
Measure the resistance according to the value(s) in the table below.

| Tester Connection | Switch Condition | Specified Condition |
| 1 (ECC) - 3 (CCS) | Neutral | 10 kΩ or higher |
| 1 (ECC) - 3 (CCS) | +RES | 235 to 245 Ω |
| 1 (ECC) - 3 (CCS) | -SET | 620 to 640 Ω |
| 1 (ECC) - 3 (CCS) | CANCEL | 1510 to 1570 Ω |
| 1 (ECC) - 3 (CCS) | Main Switch OFF | 10 kΩ or higher |
| 1 (ECC) - 3 (CCS) | Main Switch ON | Below 1 Ω |
| 2. REMOVE CRUISE CONTROL MAIN SWITCH (w/ Dynamic Laser Cruise Control System) |
Measure the resistance according to the value(s) in the table below.

| Tester Connection | Switch Condition | Specified Condition |
| 1 (ECC) - 2 (R/N) | Neutral | 10 kΩ or higher |
| 1 (ECC) - 3 (CCS) | Neutral | 10 kΩ or higher |
| 1 (ECC) - 3 (CCS) | +RES | 235 to 245 Ω |
| 1 (ECC) - 3 (CCS) | -SET | 620 to 640 Ω |
| 1 (ECC) - 3 (CCS) | CANCEL | 1510 to 1570 Ω |
| 1 (ECC) - 3 (CCS) | Main Switch OFF | 10 kΩ or higher |
| 1 (ECC) - 3 (CCS) | Main Switch ON | Below 1 Ω |
| 1 (ECC) - 2 (R/N) | Main Switch ON and MODE Switch ON | Below 1 Ω |