CRUISE CONTROL MAIN SWITCH > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE LOWER NO. 2 STEERING WHEEL COVER |
![]() |
Using a screwdriver, remove the No. 2 steering wheel cover.
| 3. REMOVE LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Using a screwdriver, remove the steering wheel cover.
| 4. REMOVE STEERING PAD |
![]() |
Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.
Pull the steering pad toward you.
![]() |
Using a thin-bladed screwdriver, release the locking button.
Using a thin-bladed screwdriver, disconnect the 2 connectors.
Detach the horn terminal.
| 5. REMOVE CRUISE CONTROL MAIN SWITCH |
![]() |
Disconnect the connector.
Remove the 2 screws.
![]() |
Remove the switch, as shown in the illustration.