Home › Power Source / Network · NETWORKING › CAN COMMUNICATION SYSTEM

DTC    U1115    Lost Communication with Tilt and Telescopic Module

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
U1115
No communication from multiplex tilt and telescopic ECU
  1. Power source circuit of multiplex tilt and telescopic ECU
  2. Multiplex tilt and telescopic ECU
  3. Multiplex tilt and telescopic ECU branch wire or connector

HINT:
w/ Seat memory


WIRING DIAGRAM


C158946E05


INSPECTION PROCEDURE

1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NEXT


2.CHECK FOR OPEN IN CAN BUS WIRE (MULTIPLEX TILT AND TELESCOPIC ECU BRANCH WIRE)


    C159590E03
  1. Disconnect the H57 multiplex tilt and telescopic ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    H57-5 (CANH) - H57-14 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE MULTIPLEX TILT AND TELESCOPIC ECU BRANCH WIRE OR CONNECTOR (CANH, CANL)
OK


3.CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BATTERY AND BODY GROUND)
  1. Reconnect the cable from the negative (-) battery terminal.

  1. Disconnect the H57 multiplex tilt and telescopic ECU connector.



    C159590E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H57-11 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    H57-2 (+B) - Body ground
    Always
    11 to 14 V
    H57-9 (ECUB) - Body ground
    H57-8 (IG) - Body ground
    Ignition switch ON



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MULTIPLEX TILT AND TELESCOPIC ECU (Click here)