AIR CONDITIONING SYSTEM > ECU Power Source Circuit |

| 1.INSPECT FUSE (A/C) |
![]() |
Remove the A/C fuse from the main body ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A/C fuse | Always | Below 1 Ω |
Reinstall the A/C fuse.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY, BODY GROUND) |
![]() |
Disconnect the H24 and H67 air conditioning amplifier connectors.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H24-14 (GND) - Body ground | Always | Below 1 Ω |
| H67-20 (RGND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| H24-21 (B) - Body ground | Always | 11 to 14 V |
| H67-24 (+B2) - Body ground | Always | 11 to 14 V |
Reconnect the air conditioning amplifier connectors.
|
| ||||
| OK | ||
| ||