Home › Engine / Hybrid System ยท 2UZ-FE › FUEL › FUEL PRESSURE PULSATION DAMPER

FUEL PRESSURE PULSATION DAMPER > INSTALLATION

for Preparation Click here



1. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY


    A162691E01
  1. Install 2 new gaskets and the fuel main hose with the fuel pressure pulsation damper.

    NOTICE:
    Make sure to install the gaskets in the order shown in the illustration, as the shape of the upper side and lower side gaskets is different.



    A185313E01
  1. Using SST, tighten the union bolt.

    SST
    09612-24014   (09617-24011)
    1. with SST

    Torque:
    33 N*m{ 340 kgf*cm , 24 ft.*lbf }

    1. without SST

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }

    HINT:
    1. This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.81 in.) and a SST with 30 mm (1.18 in.) (Click here).
    2. This torque value is effective when SST is parallel to the torque wrench.



2. INSPECT FOR FUEL LEAK
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON and turn the Techstream ON.

    NOTICE:
    Do not start the engine.

  1. Techstream:
    Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.

  1. Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.



    A133618E01
  1. Check that the pulsation damper screw rises up when the fuel pump operates.
    If the operation is not as specified, check the following parts:

    1. Fusible link
    2. Fuses
    3. Circuit opening relay
    4. Fuel pump
    5. ECM
    6. Wiring connections
    If no malfunctions are found in the aforementioned components, replace the pulsation damper.

  1. Turn the ignition switch off.

  1. Disconnect the Techstream from the DLC3.