LIGHTING SYSTEM > DRL Relay Circuit |

| 1.INSPECT MAIN BODY ECU |
![]() |
Disconnect the H3 main body ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| H3-8 (DRL) - Body ground | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (TURN SIGNAL FLASHER ASSEMBLY - MAIN BODY ECU) |
![]() |
Disconnect the H39 turn signal flasher assembly connector.
Disconnect the H3 main body ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H39-5 (DRL) - H3-8 (DRL) | Always | Below 1 Ω |
| H39-5 (DRL) - Body ground | Always | 10 kΩ or higher |
Reconnect the main body ECU connector.
Reconnect the turn signal flasher assembly connector.
|
| ||||
| OK | ||
| ||