Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Fold Down Seat Type)

FRONT SEAT ASSEMBLY (for Fold Down Seat Type) > DISASSEMBLY

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. REMOVE OCCUPANT CLASSIFICATION ECU


    B194815
  1. Disconnect the connector from the occupant classification ECU.

  1. Disengage the claw and occupant classification ECU.



2. REMOVE RECLINING ADJUSTER RELEASE HANDLE RH


    B165802E01
  1. Lift the reclining adjuster release handle.

  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the reclining adjuster release handle.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE FRONT SEAT CUSHION SHIELD RH


    B200257
  1. Remove the hog rings and rubber bands of the seatback cover from the seat frame.



    B165809E01
  1. Remove the 2 screws.

  1. Disengage the 3 claws in the order shown in the illustration, and then remove the cushion shield.



4. REMOVE INNER FRONT SEAT CUSHION SHIELD RH


    B165805E01
  1. Remove the screw.

  1. Disengage the 3 claws in the order shown in the illustration, and then remove the cushion shield.



5. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH


    B191252
  1. Disengage the 3 clamps.



    B191257
  1. Remove the nut and front seat inner belt RH.



6. REMOVE SEAT CUSHION COVER WITH PAD


    B201578
  1. Using a clip remover, remove the 2 clips.



    B191044
  1. Bend the 2 seat frame claws upward.

  1. Disengage the hooks and remove the seat cushion cover with pad.



7. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER


    B191045
  1. Remove the 10 hog rings and seat cushion cover.



8. REMOVE RECLINING ADJUSTER RELEASE HANDLE NO. 1 LH


    B165544E01
  1. Using a screwdriver with its tip wrapped in protective tape, remove the seatback lock handle as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.



9. REMOVE RECLINING ADJUSTER RELEASE HANDLE NO. 1 RH

HINT:
Use the same procedure for the LH side and RH side.



10. REMOVE SEATBACK SHIELD LH


    B191046
  1. Remove the screw.

  1. Disengage the 2 claws and remove the seatback shield.



11. REMOVE SEATBACK SHIELD RH
  1. Remove the screw.

  1. Disengage the 2 claws and remove the seatback shield.



    B165546
  1. Disconnect the airbag wire harness from the seatback shield.



12. REMOVE FRONT SEATBACK ASSEMBLY


    B191047
  1. Disengage the 2 airbag wire harness clamps from the seat frame.



    B191048
  1. Remove the 4 bolts and seatback assembly.



13. REMOVE FRONT SEATBACK BOARD


B191049
  1. Disengage the 2 clips and 2 hooks, and then remove the seatback board.



14. REMOVE FRONT SEATBACK LOCK SUB-ASSEMBLY LH


B191050
  1. Remove the 2 bolts and seatback lock sub-assembly.



15. REMOVE FRONT SEATBACK LOCK SUB-ASSEMBLY RH

HINT:
Use the same procedure for the LH side and RH side.



16. REMOVE FRONT SEATBACK LOCK HANDLE ROD


17. REMOVE FRONT SEAT HINGE COVER LH


B165551
  1. Disengage the 2 claws and remove the seat hinge cover.



18. REMOVE FRONT SEAT HINGE COVER RH

HINT:
Use the same procedure for the LH side and RH side.



19. REMOVE SEATBACK COVER WITH PAD


    B191052
  1. Remove the nut and disconnect the seatback cover bracket from the seatback spring.



    B191053
  1. Remove the 11 hog rings.



    B191054
  1. Remove the 4 hog rings.



    B191055
  1. Disengage the 4 claws and remove the 2 headrest supports.

  1. Remove the seatback cover with pad.



20. REMOVE SEPARATE TYPE FRONT SEATBACK COVER


    B191056
  1. Remove the 2 hog rings and seatback cover wires.



    B165535
  1. Disconnect the seatback cover bracket from the seatback pad.



    B191057
  1. Remove the 2 hog rings and seatback cover from the seatback pad.



21. REMOVE RECLINING ADJUSTER INSIDE COVER LH


B191058
  1. Remove the screw and reclining adjuster inside cover.



22. REMOVE RECLINING ADJUSTER INSIDE COVER RH

HINT:
Use the same procedure for the LH side and RH side.



23. REMOVE FRONT SEATBACK SHIELD LH


    B191059
  1. Remove the screw.

  1. Disengage the claw and remove the reclining adjuster inside cover.



24. REMOVE FRONT SEATBACK SHIELD RH

HINT:
Use the same procedure for the LH side and RH side.



25. REMOVE FRONT SEAT CUSHION SHIELD LOWER LH


    B201576E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the seat cushion shield.



26. REMOVE FRONT SEAT CUSHION SHIELD LOWER RH

HINT:
Use the same procedure for the LH side and RH side.



27. REMOVE FRONT SEAT WIRE RH


    B190992
  1. Disconnect the 4 connectors.

  1. Disengage the wire harness clamp and remove the front seat wire.