POWER SEAT SWITCH (for Front Seat) > INSPECTION |
| 1. INSPECT FRONT POWER SEAT SWITCH LH |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 9 (SLDF) - 1 (B) | FRONT | Below 1 Ω |
| 6 (SLDR) - 4 (E) | ||
| 9 (SLDF) - 4 (E) | OFF | |
| 6 (SLDR) - 4 (E) | ||
| 9 (SLDF) - 4 (E) | REAR | |
| 6 (SLDR) - 1 (B) |
| Tester Connection | Switch Condition | Specified Condition |
| 10 (FUP) - 1 (B) | UP | Below 1 Ω |
| 5 (FDWN) - 4 (E) | ||
| 10 (FUP) - 4 (E) | OFF | |
| 5 (FDWN) - 4 (E) | ||
| 10 (FUP) - 4 (E) | DOWN | |
| 5 (FDWN) - 1 (B) |
| Tester Connection | Switch Condition | Specified Condition |
| 7 (LUP) - 1 (B) | UP | Below 1 Ω |
| 8 (LDWN) - 4 (E) | ||
| 7 (LUP) - 4 (E) | OFF | |
| 8 (LDWN) - 4 (E) | ||
| 7 (LUP) - 4 (E) | DOWN | |
| 8 (LDWN) - 1 (B) |
| Tester Connection | Switch Condition | Specified Condition |
| 3 (RCLF) - 1 (B) | FRONT | Below 1 Ω |
| 2 (RCLR) - 4 (E) | ||
| 3 (RCLF) - 4 (E) | OFF | |
| 2 (RCLR) - 4 (E) | ||
| 3 (RCLF) - 4 (E) | REAR | |
| 2 (RCLR) - 1 (B) |
| 2. INSPECT FRONT POWER SEAT SWITCH RH |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 9 (SLDF) - 1(B) | FRONT | Below 1 Ω |
| 6 (SLDR) - 4 (E) | ||
| 9 (SLDF) - 4 (E) | OFF | |
| 6 (SLDR) - 4 (E) | ||
| 9 (SLDF) - 4 (E) | REAR | |
| 6 (SLDR) - 1 (B) |
| Tester Connection | Switch Condition | Specified Condition |
| 3 (RCLF) - 1 (B) | FRONT | Below 1 Ω |
| 2 (RCLR) - 4 (E) | ||
| 3 (RCLF) - 4 (E) | OFF | |
| 2 (RCLR) - 4 (E) | ||
| 3 (RCLF) - 4 (E) | REAR | |
| 2 (RCLR) - 1 (B) |
| 3. INSPECT LEG SUPPORT ADJUSTMENT SWITCH (w/ Leg Support Adjustment Switch) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 (CSNF) - 3 (B) | FORWARD | Below 1 Ω |
| 4 (CSNR) - 5 (E2) | ||
| 1 (CSNF) - 2 (E1) | OFF | |
| 4 (CSNR) - 5 (E2) | ||
| 1 (CSNF) - 2 (E1) | BACK | |
| 3 (B) - 4 (CSNR) |
| 4. INSPECT FRONT POWER SEAT LUMBAR SWITCH (for LH Side) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 3 (B) - 4 (H) | HOLD | Below 1 Ω |
| 1 (R) - 2 (E2) | ||
| 1 (R) - 2 (E2) | OFF | |
| 4 (H) - 5 (E) | ||
| 1 (R) - 3 (B) | RELEASE | |
| 4 (H) - 5 (E) |
| 5. INSPECT FRONT POWER SEAT LUMBAR SWITCH (for RH Side) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 3 (B) - 4 (H1) | HOLD | Below 1 Ω |
| 1 (R1) - 2 (E2) | ||
| 1 (R1) - 2 (E2) | OFF | |
| 4 (H1) - 5 (E) | ||
| 1 (R1) - 3 (B) | RELEASE | |
| 4 (H1) - 5 (E) |