POWER SEAT SWITCH (for Front Seat) > REMOVAL |
| 1. REMOVE FRONT SEAT ASSEMBLY LH (for Power Seat) |
Remove the front seat (Click here).
| 2. REMOVE FRONT SEAT ASSEMBLY LH (for Manual Seat) |
Remove the front seat (Click here).
| 3. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB (for Power Seat) |
![]() |
Apply protective tape around the cushion shield.
Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the knob.
| 4. REMOVE RECLINING POWER SEAT SWITCH KNOB (for Power Seat) |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the knob.
| 5. REMOVE VERTICAL SEAT ADJUSTER KNOB CAP (for Manual Seat) |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the vertical adjuster handle cap.
| 6. REMOVE VERTICAL ADJUSTING HANDLE LH (for Manual Seat) |
![]() |
Remove the 2 screws and vertical adjusting handle.
| 7. REMOVE VERTICAL SEAT ADJUSTER KNOB (for Manual Seat) |
![]() |
Using a screwdriver with its tip wrapped in protective tape, remove the snap ring and vertical seat adjuster knob.
| 8. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat) |
![]() |
Lift the reclining adjuster release handle.
Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the reclining adjuster release handle.
| 9. REMOVE FRONT SEAT CUSHION SHIELD LH (for Power Seat) |
![]() |
Remove the hog rings and rubber bands of the seatback cover from the seat frame.
Remove the 2 screws.
![]() |
Remove the 3 screws.
Disengage the 2 claws and remove the cushion shield.
Disconnect the connectors.
| 10. REMOVE FRONT SEAT CUSHION SHIELD LH (for Manual Seat) |
![]() |
Remove the 2 hog rings and rubber bands of the seatback cover from the seat frame.
![]() |
Remove the 3 screws.
Disengage the 3 claws in the order shown in the illustration, and then separate the front seat cushion shield.
Separate the harness from the front seat cushion shield, disconnect the connector, and remove the front seat cushion shield.
| 11. REMOVE FRONT POWER SEAT LUMBAR SWITCH (for Power Seat) |
![]() |
Disconnect the connector.
Remove the 2 screws and front power seat lumbar switch.
| 12. REMOVE FRONT POWER SEAT LUMBAR SWITCH (for Manual Seat) |
![]() |
Disconnect the connector.
Remove the 2 screws and front power seat lumbar switch.
| 13. REMOVE LEG SUPPORT ADJUSTMENT SWITCH (w/ Leg Support Adjustment Switch) |
![]() |
Disengage the 2 wire harness clamps.
Remove the 2 screws and leg support adjustment switch.
Disconnect the connector.
| 14. REMOVE FRONT POWER SEAT SWITCH LH (w/o Memory) |
![]() |
Disconnect the connector.
Remove the 3 screws and front power seat switch.