SEAT HEATER SWITCH (for Rear No. 1 Seat) > INSPECTION |
| 1. INSPECT SEAT HEATER SWITCH LH |
![]() |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 5 (HI) - 4 (E) | Switch ON (HI) | Below 1 Ω |
| 5 (HI) - 4 (E) | Switch OFF | 10 kΩ higher |
| 3 (LO) - 4 (E) | Switch ON (LO) | Below 1 Ω |
| 3 (LO) - 4 (E) | Switch OFF | 10 kΩ higher |
Check the illumination operation.
Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.
| Measurement Condition | Switch Condition | Specified Condition |
| Battery positive (+) → 6 (ILL+) Battery negative (-) → 4 (E) | Always | Illuminates |
Check the indicator operation.
Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.
| Measurement Condition | Switch Condition | Specified Condition |
| Battery positive (+) → 7 (IG) Battery negative (-) → 8 (HI IND) | Switch ON (HI) | Illuminates |
| Battery positive (+) → 7 (IG) Battery negative (-) → 2 (LO IND) | Switch ON (LO) | Illuminates |
| 2. INSPECT SEAT HEATER SWITCH RH |
![]() |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 5 (HI) - 4 (E) | Switch ON (HI) | Below 1 Ω |
| 5 (HI) - 4 (E) | Switch OFF | 10 kΩ higher |
| 3 (LO) - 4 (E) | Switch ON (LO) | Below 1 Ω |
| 3 (LO) - 4 (E) | Switch OFF | 10 kΩ higher |
Check the illumination operation.
Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.
| Measurement Condition | Switch Condition | Specified Condition |
| Battery positive (+) → 6 (ILL+) Battery negative (-) → 4 (E) | Always | Illuminates |
Check the indicator operation.
Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.
| Measurement Condition | Switch Condition | Specified Condition |
| Battery positive (+) → 7 (IG) Battery negative (-) → 8 (HI IND) | Switch ON (HI) | Illuminates |
| Battery positive (+) → 7 (IG) Battery negative (-) → 2 (LO IND) | Switch ON (LO) | Illuminates |