Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR OPENER SWITCH

BACK DOOR OPENER SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL BACK DOOR OUTSIDE HANDLE


    B190531
  1. Install the back door outside handle with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Engage the clamp.

  1. Connect the connector.



2. INSTALL BACK DOOR SERVICE HOLE COVER


B190522
  1. Apply butyl tape to the door panel, then install a new back door service hole cover as shown in the illustration.

    HINT:
    1. There should be no wrinkles or folds after attaching the service hole cover.
    2. After attaching the service hole cover, check the quality of the seal.



3. INSTALL BACK DOOR TRIM BOARD ASSEMBLY


B190520
  1. Engage the 11 clips and install the back door trim board assembly.



4. INSTALL BACK DOOR PULL STRAP


B190519
  1. Install the back door pull strap with the bolt.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }



5. INSTALL BACK DOOR STRAP COVER


B195035
  1. Engage the claw and slid the back door strap cover as shown in the illustration, and install it.



6. INSTALL BACK DOOR SIDE GARNISH LH


B190516
  1. Engage the 3 clips and install the back door side garnish LH.



7. BACK DOOR SIDE GARNISH RH


B190515
  1. Engage the 2 clips and install the back door side garnish RH.



8. INSTALL BACK DOOR CENTER GARNISH


B190514
  1. Engage the 4 clips and the claw and install the back door center garnish.



9. INSTALL POWER BACK DOOR ROD (w/ Power Back Door)


B194234
  1. Install the power back door rod with the 2 stop rings.