STEERING PAD > INSTALLATION |
| 1. INSTALL STEERING PAD |
![]() |
Confirm that the ignition switch is turned off.
Confirm that the negative battery terminal is disconnected.
Connect the horn terminal.
Connect the airbag connector.
Install the steering pad.
![]() |
Using "TORX" socked wrench T30, tighten the 2 screws.
| 2. INSTALL LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Attach the 2 claws to install the cover.
| 3. INSTALL LOWER NO. 2 STEERING WHEEL COVER |
![]() |
Attach the 2 claws to install the cover.
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. INSPECT STEERING PAD |
With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
Cuts, small cracks or marked discoloration on the steering pad top surface or in the grooved portion.
Check that the horn sounds.
If the horn does not sound, inspect the horn system.
| 6. CHECK SRS WARNING LIGHT |