SPIRAL CABLE > INSTALLATION |
| 1. INSTALL STEERING SENSOR |
![]() |
Align the pins on the spiral cable with the installation holes on the steering sensor.
Attach the 6 claws and install the spiral cable to the steering sensor.
Check that the front wheels are facing straight ahead.
Set the turn signal switch to the neutral position.
| 2. INSTALL SPIRAL CABLE |
![]() |
Attach the 3 claws and install the spiral cable with steering sensor.
Connect the connectors to the spiral cable with steering sensor.
| 3. INSTALL UPPER STEERING COLUMN COVER |
![]() |
Attach the claw to install the upper steering column cover.
Attach the 4 clips.
| 4. INSTALL LOWER STEERING COLUMN COVER |
![]() |
Attach the 2 claws to install the lower steering column cover.
Install the 2 screws.
| 5. ADJUST SPIRAL CABLE |
![]() |
Check that the ignition switch is off.
Check that the battery negative (-) terminal is disconnected.
Rotate the spiral cable with steering sensor counterclockwise slowly by hand until it feels firm.
![]() |
Rotate the spiral cable with steering sensor clockwise approximately 2.5 turns to align the marks.
| 6. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Align the matchmarks on the steering wheel and steering main shaft.
Install the steering wheel set nut.
| 7. INSTALL STEERING PAD |
![]() |
Confirm that the ignition switch is turned off.
Confirm that the negative battery terminal is disconnected.
Connect the horn terminal.
Connect the airbag connector.
Install the steering pad.
![]() |
Using "TORX" socked wrench T30, tighten the 2 screws.
| 8. INSTALL LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Attach the 2 claws to install the cover.
| 9. INSTALL LOWER NO. 2 STEERING WHEEL COVER |
![]() |
Attach the 2 claws to install the cover.
| 10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 11. INSPECT STEERING PAD |
With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
Cuts, small cracks or marked discoloration on the steering pad top surface or in the grooved portion.
Check that the horn sounds.
If the horn does not sound, inspect the horn system.
| 12. INSPECT SRS WARNING LIGHT |
Check the SRS warning light (Click here).