Home › Suspension › FRONT SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > DISASSEMBLY

for Preparation Click here



1. REMOVE FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT


C159781E01
  1. Using SST, compress the coil spring.

    SST
    09727-30021  

    NOTICE:
    1. Make sure that the suspension support is free from the coil spring.
    2. Do not compress the coil spring more than necessary.
    3. Do not use an impact wrench. It will damage SST.
    4. Do not place yourself over the top of the shock absorber.

    CAUTION:
    Be careful as the coil spring may spring upward and cause an injury.



    C155969
  1. Remove the front support to front shock absorber nut.



2. REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY LH
  1. Remove the suspension support, 2 retainers and 2 cushions from the shock absorber rod (w/o AVS).

  1. Remove the suspension support, 2 retainers, 2 cushions and collar from the shock absorber rod (w/AVS).



3. REMOVE FRONT COIL SPRING LH
  1. Remove the coil spring from the shock absorber.