Home › Engine / Hybrid System ยท 2UZ-FE › ENGINE CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > REMOVAL

for Preparation Click here


CAUTION:
  1. The procedures should be performed by at least 2 people.
  2. Wear protective gloves when removing the exhaust pipe.
  3. The exhaust pipe is extremely hot immediately after the engine has stopped.
  4. Confirm that the exhaust pipe has cooled down before removing it.



1. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY (for 4WD)


    A185632
  1. Disconnect the air fuel ratio sensor connector.

  1. Disconnect the heated oxygen sensor connector.

  1. Remove the 2 bolts and 2 nuts from the front No. 3 exhaust pipe sub-assembly.

  1. Remove the 3 nuts and front No. 2 exhaust pipe assembly pipe.



2. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2 2WD)


    A185637
  1. Disconnect the heated oxygen sensor connector.



    A185638
  1. Using SST, remove the heated oxygen sensor.

    SST
    09224-00010  



3. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2 4WD)


    A155873E02
  1. Using SST, remove the heated oxygen sensor.

    SST
    09224-00010  



4. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)


    A185640
  1. Disconnect the heated oxygen sensor connector.



    A185641
  1. Using SST, remove the heated oxygen sensor.

    SST
    09224-00010