DTC P060B Internal Control Module A/D Processing Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P060B | ECM main CPU communication error | ECM |
| Related DTCs | None |
| Required sensors/components (main) | ECM |
| Required sensors/components (sub) | - |
| Frequency of operation | Once per driving cycle |
| Duration | 16 seconds |
| MIL operation | Immediate |
| Sequence of operation | None |
| Monitor runs whenever following DTCs not present | None |
| When one of following conditions is met | condition 1, 2 or 3 |
| 1. Internal control module serial communication | Fail |
| 2. AD Converter | Fail |
| 3. Knock sensor circuit | Fail |
| 1.CHECK DTC |
Clear DTC (Click here).
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Turn the ignition switch to ON.
Check DTC.
|
| ||||
| OK | ||
| ||