Home › Engine / Hybrid System ยท 3UR-FBE › ENGINE CONTROL › SFI SYSTEM

DTC    P060E    Internal Control Module Throttle Position Performance

for Preparation Click here


DESCRIPTION

The ECM monitors the input signals of the Throttle Position (TP) sensor No. 1 and stop light switch. As the ECM monitors the input signals of the TP sensor No. 1 and the STP signals of the stop light switch, if the input signals and control signals are deviated, a DTC is output.

DTC No.
DTC Detection Condition
Trouble Area
P060E
When either condition below is met:
  1. ECM main CPU error
  2. ECM sub CPU error
ECM

MONITOR STRATEGY


Related DTCs
None
Required sensors / components (main)
ECM
Required sensors / components (sub)
-
Frequency of operation
Once per driving cycle
Duration
1 second
MIL operation
Immediate
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


Monitor runs whenever following DTCs not present
None
DMA communication error
Not detected

TYPICAL MALFUNCTION THRESHOLDS


When one of following conditions is met:
Condition 1 or 2
1. Difference of main TP and sub TP
0.3 V or more
2. Difference of main brake switch signal and sub brake switch signal
Different

INSPECTION PROCEDURE

1.CHECK DTC
  1. Clear DTC (Click here).

  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) battery terminal.

  1. Turn the ignition switch to ON.

  1. Check DTC.

    OK:
    P060E is not present.



NG
REPLACE ECM (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)