Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream ON.

  4. Enter the following menus: Body Electrical, Powertrain or Chassis / (desired system) / Data List.

  5. According to the display on the Techstream, read the Data List.

    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Tail Cancel SW*1
    TAIL cancel switch condition/ON or OFF
    ON: TAIL cancel switch ON
    OFF: TAIL cancel switch OFF
    -
    ODO/TRIP Change SW
    Trip switch (ODO/TRIP switch) condition/ON or OFF
    ON: Trip switch (ODO/TRIP switch) pushed
    OFF: Trip switch (ODO/TRIP switch) not pushed
    -
    Vehicle Speed Meter
    Vehicle speed/Min.: 0 (0), Max.: 255 (158)
    Almost same as actual vehicle speed (when driving)
    Unit: km/h (mph)
    Engine Rpm
    Engine speed/Min.: 0, Max.: 12750
    Idling: 650 to 750
    Unit: rpm
    Coolant Temperature
    Engine coolant temperature/Min.: 0 (-40), Max.: 140 (284)
    After warming up: 80 to 100 (176 to 212)
    1. Unit: °C (°F)
    2. If value -40 (-40): sensor circuit open
    3. If value 140 (284): sensor circuit shorted
    Washer Switch
    Washer switch/ON or OFF
    ON: Washer switch ON
    OFF: Washer switch OFF
    -
    +B Voltage Value
    +B voltage/Min.: 0, Max.: 25.5
    Below 1 to 14
    Unit: V
    Integrated value for Oil Maintenance
    Integrated value for oil maintenance warning/Min.: 0 (0), Max.: 25500 (41037)
    0 (0) to 25500 (41037)
    Unit: mile (km)
    Fuel Input
    Fuel sender gauge input/Min.: 0, Max.: 127.5
    Fuel sender input value
    Unit: L
    Ambient Temperature
    Ambient temperature/Min.: -40°C, Max.: 87.5°C
    Same as outside temperature
    Unit: °C (°F)
    Rheostat value
    Light control rheostat switch input/Min.: 0, Max.: 100
    Light control rheostat switch is Dark (0) → Bright (100)
    Unit: %
    Quantity of Outside Light
    Outside dimmer output/Min.: 0, Max.: 100
    0 to 100
    Unit: %
    Communication ECM/Meter DTC 1
    ECM communication stop history/Rec or Unrec
    Rec: DTC is recorded
    Unrec: DTC is not recorded
    -
    ECM ODO (History 1)
    ECM odometer history/Min.: 0, Max.: 999999
    With history: 0 to 999999
    Without history: ffffffh
    -
    Communication ECM/Meter DTC 2
    ECM communication stop history/Rec or Unrec
    Rec: DTC is recorded
    Unrec: DTC is not recorded
    -
    ECM ODO (History 2)
    ECM odometer history/Min.: 0, Max.: 999999
    With history: 0 to 999999
    Without history: ffffffh
    -
    Communication ECM/Meter DTC 3
    ECM communication stop history/Rec or Unrec
    Rec: DTC is recorded
    Unrec: DTC is not recorded
    -
    ECM ODO (History 3)
    ECM odometer history/Min.: 0, Max.: 999999
    With history: 0 to 999999
    Without history: ffffffh
    -
    Communication ABS/Meter DTC 1
    Skid control ECU communication stop history/Rec or Unrec
    Rec: DTC is recorded
    Unrec: DTC is not recorded
    -
    ABS/VSC ODO (History 1)
    Skid control ECU odometer history/Min.: 0, Max.: 999999
    With history: 0 to 999999
    Without history: ffffffh
    -
    Communication ABS/Meter DTC 2
    Skid control ECU communication stop history/Rec or Unrec
    Rec: DTC is recorded
    Unrec: DTC is not recorded
    -
    ABS/VSC ODO (History 2)
    Skid control ECU odometer history/Min.: 0, Max.: 999999
    With history: 0 to 999999
    Without history: ffffffh
    -
    Communication ABS/Meter DTC 3
    Skid control ECU communication stop history/Rec or Unrec
    Rec: DTC is recorded
    Unrec: DTC is not recorded
    -
    ABS/VSC ODO (History 3)
    Skid control ECU odometer history/Min.: 0, Max.: 999999
    With history: 0 to 999999
    Without history: ffffffh
    -
    Key Remind Sound
    Key reminder sound/FAST, NORMAL or SLOW
    Displays key reminder buzzer speed setting
    -
    Key Remind Volume
    Key reminder volume/LARGE, MEDIUM or SMALL
    Displays key reminder buzzer volume setting
    -
    Driver Side Warning Buzzer
    Front driver side seat belt warning buzzer setting/ON or OFF
    ON: Front driver side seat belt warning buzzer ON setting
    OFF: Front driver side seat belt warning buzzer OFF setting
    -
    P-Seatbelt Warning Buzzer
    Front passenger side seat belt warning buzzer setting/ON or OFF
    ON: Front passenger side seat belt warning buzzer ON setting
    OFF: Front passenger side seat belt warning buzzer OFF setting
    -

    1. *1: w/ TAIL cancel switch

    Engine 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Engine Speed
    Engine speed/Min.: 0, Max.: 16383
    Idling: 650 to 750
    Unit: rpm
    Vehicle Speed
    Vehicle speed/Min.: 0 (0), Max.: 255 (158)
    Actual vehicle speed
    1. Unit: km/h (mph)
    2. Speed indicated on speedometer
    Coolant Temp
    Engine coolant temperature/Min.: -40 (-40), Max.: 140 (284)
    After warming up: 80 to 100 (176 to 212)
    1. Unit: °C (°F)
    2. If value -40 (-40): sensor circuit open
    3. If value 140 (284): sensor circuit shorted

    ABS/VSC/TRAC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    (FL/FR/RL/RR) Wheel Speed
    Wheel speed sensor (FL/FR/RL/RR) reading/Min.: 0 (0), Max.: 326 (202)
    Actual wheel speed
    Similar speed as indicated on speedometer


ACTIVE TEST

HINT:
Using the Techstream to perform the Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream ON.

  4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  5. According to the display on the Techstream, perform the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Speed Meter Operation*7
    Speedometer
    0, 40, 80, 120, 160, 200, 240 or 280
    Perform the test with the vehicle stopped and engine idling
    Tacho Meter Operation
    Tachometer
    0, 1000, 2000, 3000, 4000, 5000, 6000 or 7000
    Perform the test with the vehicle stopped and engine idling
    Fuel Meter Operation
    Fuel receiver gauge
    EMPTY, 1/2 or FULL
    Perform the test with the vehicle stopped and engine idling
    Water Temperature Meter Operation
    Engine coolant temperature receiver gauge
    LOW, NORMAL or HIGH
    Perform the test with the vehicle stopped and engine idling
    Volt Meter Operation
    Voltmeter
    0, 3, 6, 9, 12, 15 or 18
    Perform the test with the vehicle stopped and engine idling
    Oil Pressure Meter Operation
    Oil pressure receiver gauge
    LOW, 1/4, 1/2, 3/4 or HIGH
    Perform the test with the vehicle stopped and engine idling
    A/T Indicator operation 1
    A/T indicator (normal mode)
    P, R, N, D, 4, 3, 2, L
    Perform the test with the vehicle stopped and engine idling
    A/T Indicator operation 2
    A/T indicator (sequential mode)
    Es, 5*5 or 6*6
    Perform the test with the vehicle stopped and engine idling
    Indicat. Lamp Airbag
    SRS warning light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Lamp Doors All Open
    All doors open light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Front Passenger Side Seat Belt
    Passenger side seat belt warning light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Driver Side Seat Belt
    Driver side seat belt warning light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Lamp ABS
    ABS warning light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Lamp VSC
    VSC OFF indicator light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Lamp Slip
    SLIP indicator light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Lamp Beam
    BEAM indicator light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Lamp Head*1
    HEAD indicator light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Lamp Tail*2
    TAIL indicator light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Lamp Fuel
    Low fuel warning light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Tire Pressure Warning System
    Tire pressure warning light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    A/T Oil Temperature Operation
    A/T OIL TEMP warning light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. 4WD
    4WD indicator light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Lamp Cruise
    CRUISE main indicator light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Lamp Brake
    Brake warning light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. EPS
    EPS warning light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Oil Maintenance*3
    Oil maintenance warning light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Master Warning*4
    Master warning light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Auto LSD
    AUTO LSD indicator light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Meter Display 1*8
    All dots in the multi-information display
    ALL or OFF
    Perform the test with the vehicle stopped and engine idling

    1. *1: for U.S.A.
    2. *2: except U.S.A.
    3. *3: w/o Multi-information display
    4. *4: w/ Multi-information display
    5. *5: for 2UZ-FE
    6. *6: for 3UR-FE, 3UR-FBE

    HINT:
    *7:
    1. It is normal that door will be locked automatically when performing the speedometer Active Test.
    2. The displayed value has the same units (km/h, mph) as the main scale of the vehicle speedometer.
    3. The needle position should be within the acceptable tolerance.
    *8: If this Active Test is being performed and the ignition switch is turned off and then ON, the A/T and ODO/TRIP display background may turn white. If this occurs, end this Active Test and turn the ignition switch off.