Home › Engine / Hybrid System ยท 3UR-FBE › FUEL › FUEL SENDER GAUGE ASSEMBLY

FUEL SENDER GAUGE ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL FUEL SENDER GAUGE ASSEMBLY


    A201439E01
  1. Slide the fuel sender gauge onto the fuel suction support to install it.



    A201437
  1. Attach the 2 claws to connect the wire harness.



    A194662E01
  1. Insert the 2 wire terminals into the connector.

    NOTICE:
    1. When inserting the wire terminals into the connector, be sure to insert the positive (+) terminal and negative (-) terminal into the correct locations.
    2. Be careful not to deform the terminals.



    A194661E01
  1. Attach the 2 claws to install the cover to the back end of the connector, and then install the cap.



    A194625E01
  1. Connect the connector to the fuel suction plate.



2. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
  1. Install the fuel suction with pump and gauge tube assembly (Click here).