Home › Vehicle Interior › LIGHTING (INT) › GLOVE BOX LIGHT

GLOVE BOX LIGHT > INSPECTION

for Preparation Click here



1. INSPECT GLOVE BOX LIGHT ASSEMBLY


  1. Check the resistance.



      E146129E02
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      1 - 2
      Pushed
      10 kΩ or higher
      1 - 2
      Not pushed
      Below 1 Ω

      If the result is not as specified, replace the light assembly.