REAR DOOR LOCK > REMOVAL |
| 1. REMOVE REAR DOOR FRAME GARNISH |
![]() |
Disengage the 6 clips and remove the rear door frame garnish.
| 2. REMOVE REAR DOOR ARMREST BASE UPPER PANEL |
![]() |
Disengage the 2 clips and 5 claws and remove the rear door armrest base upper panel.
| 3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG |
![]() |
Using a moulding remover, disengage the 4 claws and remove the rear door inside handle bezel plug.
| 4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY |
![]() |
Remove the rear door armrest cover.
Remove the 2 screws.
![]() |
Disengage the 9 clips.
Disconnect the connector.
![]() |
Disconnect the rear door lock remote control cable and the rear door inside locking cable and remove the rear door trim board sub-assembly.
| 5. REMOVE REAR DOOR TRIM NO. 2 BRACKET |
![]() |
Remove the 2 screws and remove the rear door trim No. 2 bracket.
| 6. REMOVE REAR DOOR SERVICE HOLE COVER |
![]() |
Disengage the clamps and disconnect the connectors.
![]() |
Remove the rear door service hole cover.
| 7. REMOVE REAR DOOR GLASS RUN |
![]() |
Remove the front door glass run.
| 8. REMOVE REAR DOOR WINDOW FRAME REAR LOWER SUB-ASSEMBLY |
![]() |
Loosen nut A.
Remove the 3 bolts and remove the rear door window frame rear lower sub-assembly.
| 9. REMOVE REAR DOOR GLASS SUB-ASSEMBLY |
![]() |
Provisionally install the power window switch.
Move the rear door glass until the 2 bolts can be seen through the service holes.
Remove the 2 bolts and remove the rear door glass sub-assembly.
| 10. REMOVE REAR DOOR LOCK |
![]() |
Using a "TORX" socket wrench T30, remove the 3 screws.
Move the rear door lock downward and pull the release plate out of the rear door outside handle frame.
Remove the door lock wire harness seal from the rear door lock.
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the claw and open the cover.
![]() |
Remove the rear door lock remote control cable.
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and open the cover.
![]() |
Remove the rear door inside locking cable.