STEERING COLUMN ASSEMBLY (for Manual Tilt and Manual Telescopic Steering Column) > REASSEMBLY |
| 1. INSTALL STEERING COLUMN BRACKET SPACER |
![]() |
Fix the steering column in a vise between aluminum plates or a cloth. Then install the steering column bracket spacer to the steering column.
| 2. INSTALL BREAK AWAY CAPSULE |
![]() |
Install the 2 break away capsules and 2 break away collars to the steering column.
| 3. INSTALL IGNITION SWITCH ASSEMBLY |
![]() |
Attach the 2 claws to install the ignition switch to the steering lock.
| 4. INSTALL KEY INTERLOCK SOLENOID |
![]() |
Install the key interlock solenoid to the steering lock with the 2 screws.
| 5. INSTALL UNLOCK WARNING SWITCH ASSEMBLY |
![]() |
Attach the 2 claws to install the unlock warning switch to the steering lock.
| 6. INSTALL IGNITION SWITCH LOCK CYLINDER |
Check that the ignition switch lock cylinder is in the ACC position.
![]() |
Install the ignition switch lock cylinder to the steering lock sub-assembly.
Check that the ignition switch lock cylinder assembly is securely installed.
| 7. INSPECT STEERING LOCK OPERATION |
| 8. INSTALL UPPER STEERING COLUMN WITH SWITCH BRACKET ASSEMBLY |
Temporarily install the upper steering column with switch bracket and steering lock bracket with 2 new tapered-head bolts.
![]() |
Tighten the 2 tapered-head bolts until the bolt heads break off.
| 9. INSTALL TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System) |
Align the transponder key amplifier with the installation position of the upper bracket with the amplifier inclined.
![]() |
Push the transponder key amplifier upward and install it to the upper bracket.
| 10. INSTALL KEY CYLINDER LIGHT ASSEMBLY (w/o Engine Immobiliser System) |
Align the key cylinder light with the installation position of the upper bracket with the key cylinder light inclined.
![]() |
Push the key cylinder light upward and install it to the upper bracket.