NAVIGATION RECEIVER > INSTALLATION |
| 1. INSTALL NO. 1 RADIO BRACKET |
![]() |
Install the bracket with the 4 bolts.
| 2. INSTALL NO. 2 RADIO BRACKET |
![]() |
Install the bracket with the 4 bolts.
| 3. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET |
![]() |
Connect the connectors.
Insert the navigation receiver as shown in the illustration to engage the 3 clips on its backside.
![]() |
Install the navigation receiver with the 4 bolts.
| 4. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY |
![]() |
Connect the connectors.
Engage the 4 clips and install the panel.
| 5. INSTALL CENTER LOWER INSTRUMENT PANEL FINISH PANEL |
![]() |
Connect the connectors.
Engage the 4 clips and 2 claws and install the finish panel.
| 6. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
![]() |
Engage the 12 clips and install the finish panel.
Connect the 2 connectors and clamp.
![]() |
Engage the 4 claws and install the instrument panel finish panel retainer.
| 7. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Connect the connectors.
Engage the 6 clips and install the console panel.
Install the clip.
| 8. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Engage the 12 clips and install the console panel.
| 9. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY |
![]() |
Install the shift lever knob and twist it in the direction indicated by the arrow.
| 10. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
![]() |
Engage the 2 claws and install the sensor.
Connect the connectors.
Engage the 4 clips and claw and install the finish panel.
Install the 2 <A> bolts.
| 11. INSTALL INSTRUMENT SIDE PANEL LH |
![]() |
Engage the 4 guides and 3 claws and install the side panel.
| 12. INSTALL COWL SIDE TRIM BOARD LH |
| 13. INSTALL FRONT DOOR SCUFF PLATE LH |