RADIO RECEIVER > REMOVAL |
| 1. REMOVE FRONT DOOR SCUFF PLATE LH |
| 2. REMOVE COWL SIDE TRIM BOARD LH |
| 3. REMOVE INSTRUMENT SIDE PANEL LH |
![]() |
Apply protective tape, as shown in the illustration.
Using a moulding remover, disengage the 3 claws and 4 guides and remove the side panel.
| 4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
![]() |
Remove the 2 <A> bolts.
Disengage the 4 clips and claw.
Disengage the 2 claws and separate the sensor.
Disconnect the connectors and remove the finish panel.
| 5. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY |
![]() |
Twist the shift lever knob in the direction indicated by the arrow and remove it.
| 6. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Disengage the 12 clips and remove the console panel.
| 7. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Move the shift lever to N.
Remove the clip.
Disengage the 6 clips and remove the console panel.
Disconnect the connector
| 8. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
![]() |
Disengage the 4 claws and separate the instrument panel finish panel retainer.
![]() |
Disconnect the 2 connectors and clamp.
Disengage the 12 clips and remove the finish panel.
| 9. REMOVE CENTER LOWER INSTRUMENT PANEL FINISH PANEL |
![]() |
Disengage the 4 clips and 2 claws.
Disconnect the connectors and remove the finish panel.
| 10. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY |
![]() |
Disengage the 4 clips and separate the panel.
Disconnect the connectors and remove the panel.
| 11. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET |
![]() |
Remove the 4 bolts.
![]() |
Pull the radio receiver to disengage the 3 clips on the backside of the radio receiver.
Disconnect the connectors and remove the radio receiver.
| 12. REMOVE NO. 2 RADIO BRACKET |
![]() |
Remove the 3 bolts and bracket.
| 13. REMOVE NO. 1 RADIO BRACKET |
![]() |
Remove the 3 bolts and bracket.