Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The stereo jack adapter assembly sends an external device sound signal to the navigation receiver assembly through this circuit. The sound signal that has been sent is amplified by stereo component amplifier assembly, and then is sent to speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, navigation receiver assembly, or speakers.

WIRING DIAGRAM


E138084E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - STEREO JACK ADAPTER)


    E138085E02
  1. Disconnect the I5 navigation receiver assembly connector.

  1. Disconnect the H7 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I5-3 (VAL+) - H7-1 (ALO)
    Always
    Below 1 Ω
    I5-2 (VAR+) - H7-2 (ARO)
    I5-5 (VA-) - H7-3 (ASGN)
    I5-5 (VA-) - H7-5 (AUXG)
    I5-6 (ADPG) - H7-4 (AUXO)
    I5-3 (VAL+) - Body ground
    Always
    10 kΩ or higher
    I5-2 (VAR+) - Body ground
    I5-5 (VA-) - Body ground
    I5-6 (ADPG) - Body ground

  1. Reconnect the navigation receiver assembly connector.

  1. Reconnect the stereo jack adapter assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)