Home › Vehicle Exterior › WIPER / WASHER › FRONT WIPER MOTOR

FRONT WIPER MOTOR > INSPECTION

for Preparation Click here



1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY


    E145558E06
  1. Check the LO operation.

    1. Connect the positive (+) battery lead to terminal 1 (+1) of the connector and the negative (-) battery lead to terminal 5 (E), and check that the motor operates at low speed (LO).

      OK:
      Motor operates at low speed (LO).

      If the result is not as specified, replace the motor assembly.

  1. Check the HI operation.

    1. Connect the positive (+) battery lead to terminal 4 (+2) of the connector and the negative (-) battery lead to terminal 5 (E), and check that the motor operates at high speed (HI).

      OK:
      Motor operates at high speed (HI).

      If the result is not as specified, replace the motor assembly.



    E146304E04
  1. Check the automatic stop operation.

    1. Connect the positive (+) battery lead to terminal 1 (+1) of the connector and the negative (-) battery lead to terminal 5 (E). With the motor operating at low speed (LO), disconnect terminal 1 (+1) to stop the wiper motor operation at any position other than the automatic stop position.

    2. Connect terminals 3 (S) and 1 (+1). Then connect the positive (+) battery lead to terminal 2 (B) of the connector to restart the motor operation at low speed (LO).

    3. Check that the motor stops automatically at the automatic stop position.

      OK:
      Automatically stops.

      If the result is not as specified, replace the motor assembly.