Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Oil Pressure Gauge Malfunction

for Preparation Click here


DESCRIPTION

The oil pressure sender detects the oil pressure generated when the engine is started. The combination meter determines that the engine is running when the engine speed is 400 rpm or more, and determines that the engine is cranking when the engine speed is 200 rpm or less. The oil pressure receiver gauge detects and indicates the oil pressure applied to the oil pressure sender.

WIRING DIAGRAM


E146600E10


INSPECTION PROCEDURE

1.CHECK DTC
  1. Use the Techstream to check if the CAN communication system is functioning normally (Click here).
    Result 
    Result
    Proceed to
    CAN communication system DTC is not output
    A
    CAN communication system DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.PERFORM ACTIVE TEST USING TECHSTREAM (OIL PRESSURE RECEIVER GAUGE)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream ON.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  1. According to the display on the Techstream, perform the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Oil Pressure Meter Operation
    Oil pressure receiver gauge
    LOW, 1/4, 1/2, 3/4 or HIGH
    Perform the test with the vehicle stopped and engine idling

    OK:
    Needle indication is normal.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


3.INSPECT OIL PRESSURE GAUGE ASSEMBLY (OIL PRESSURE SENDER GAUGE)
A163798E02
  1. Disconnect the D57 or E13 gauge connector.

  1. Apply battery positive (+) voltage to the sender gauge terminal through a test LED.

  1. Check that the LED does not illuminate when the engine is stopped.

  1. Check that the LED flashes when the engine is running. The number of flashes varies with engine speed.

    OK:
    LED flashes when engine is running.
    LED does not illuminate when engine is stopped.

    Result 
    Result
    Proceed to
    LED operates correctly according to engine condition
    A
    LED does not operate correctly according to engine condition (for 2UZ-FE)
    B
    LED does not operate correctly according to engine condition (for 3UR-FE)
    C
    LED does not operate correctly according to engine condition (for 3UR-FBE)
    D



B
REPLACE OIL PRESSURE SENDER GAUGE ASSEMBLY (Click here)

C
REPLACE OIL PRESSURE SENDER GAUGE ASSEMBLY (Click here)

D
REPLACE OIL PRESSURE SENDER GAUGE ASSEMBLY (Click here)
A


4.CHECK HARNESS AND CONNECTOR (COMBINATION METER - OIL PRESSURE SENDER GAUGE)


    E146615E05
  1. Disconnect the H37 meter connector.

  1. Disconnect the D57 or E13 gauge connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H37-11 (S) - D57-1 or E13-1
    Always
    Below 1 Ω
    H37-11 (S) - Body ground
    Always
    10 kΩ or higher
    D57-1 or E13-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)