CYLINDER HEAD > REPLACEMENT |
| 1. REPLACE INTAKE VALVE GUIDE BUSH |
![]() |
Gradually heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
Place the cylinder head on wooden blocks.
![]() |
Using SST and a hammer, tap out the guide bush.
![]() |
Using a caliper gauge, measure the bush bore diameter of the cylinder head.
![]() |
Select a new guide bush (STD or O/S 0.05).
| Item | Specified Condition |
| Intake | 34.5 mm (1.36 in.) |
| Exhaust | 40.5 mm (1.59 in.) |
Machine the bush bore diameter of the cylinder head side to the diameter of the selected guide bush.
| Bush Size | Specified Condition |
| Use STD | 10.285 to 10.306 mm (0.405 to 0.406 in.) |
| Use O/S 0.05 | 10.335 to 10.356 mm (0.407 to 0.408 in.) |
Gradually heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
![]() |
Using SST and a hammer, tap in a new guide bush to the specified protrusion height.
![]() |
Using a sharp 5.5 mm reamer, ream the guide bush to obtain the standard clearance between the guide bush and valve stem.
| 2. REPLACE EXHAUST VALVE GUIDE BUSH |
![]() |
Gradually heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
Place the cylinder head on wooden blocks.
![]() |
Using SST and a hammer, tap out the guide bush.
![]() |
Using a caliper gauge, measure the bush bore diameter of the cylinder head.
![]() |
Select a new guide bush (STD or O/S 0.05).
| Item | Specified Condition |
| Intake | 34.5 mm (1.36 in.) |
| Exhaust | 40.5 mm (1.59 in.) |
Machine the bush bore diameter of the cylinder head side to the diameter of the selected guide bush.
| Bush Size | Specified Condition |
| Use STD | 10.285 to 10.306 mm (0.405 to 0.406 in.) |
| Use O/S 0.05 | 10.335 to 10.356 mm (0.407 to 0.408 in.) |
Gradually heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
![]() |
Using SST and a hammer, tap in a new guide bush to the specified protrusion height.
![]() |
Using a sharp 5.5 mm reamer, ream the guide bush to obtain the standard clearance between the guide bush and valve stem.
| 3. REPLACE SPARK PLUG TUBE |
![]() |
Remove the spark plug tubes.
Apply adhesive to the end of a new spark plug tube.
![]() |
Using a wooden block and hammer, tap in the spark tube.
| 4. REPLACE RING PIN |
Remove the ring pin.
Using a plastic-faced hammer, tap in new ring pins until they stop.
