Home › Engine / Hybrid System ยท 2UZ-FE › ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > DISASSEMBLY

for Preparation Click here



1. REMOVE INTAKE VALVE


    A050250E02
  1. Using SST, compress the compression spring and remove the 2 valve spring retainer locks.

    SST
    09202-70020  

  1. Remove the spring retainer, compression spring, valve and spring seat.

    HINT:
    Arrange the removed parts in the correct order.



2. REMOVE EXHAUST VALVE


    A050249E01
  1. Using SST, compress the compression spring and remove the 2 valve spring retainer locks.

    SST
    09202-70020  

  1. Remove the spring retainer, compression spring, valve and spring seat.

    HINT:
    Arrange the removed parts in the correct order.



3. REMOVE VALVE STEM OIL SEAL


    A050489E02
  1. Using needle nose pliers, remove the oil seals.



4. REMOVE VALVE SPRING SEAT


    A123801
  1. Using compressed air and a magnetic finger, remove the valve spring seat by blowing air onto it.



5. REMOVE NO. 1 STRAIGHT SCREW PLUG


    A168573
  1. Using a 14 mm hexagon wrench, remove the screw plugs and gasket.



6. REMOVE STUD BOLT

NOTICE:
If the stud bolt is deformed or its threads are damaged, replace it.