CYLINDER HEAD > REASSEMBLY |
| 1. INSTALL STUD BOLT |
Remove the stud bolts.
Using an E10 "TORX" socket wrench, install the stud bolt B and install the stud bolt A and C.

| 2. INSTALL NO. 1 STRAIGHT SCREW PLUG |
![]() |
Using a 14 mm hexagon wrench, install 2 new gaskets and the 2 straight screw plugs.
| 3. INSTALL VALVE SPRING SEAT |
Install the valve spring seats to the cylinder head.
| 4. INSTALL VALVE STEM OIL SEAL |
![]() |
Apply a light coat of engine oil to a new oil seal.
![]() |
Using SST, push in the new oil seal.
| 5. INSTALL INTAKE VALVE |
![]() |
Apply plenty of engine oil to the tip area of the intake valve shown in the illustration.
Install the valve, valve spring seat, compression spring and spring retainer to the cylinder head.
![]() |
Using SST, compress the compression spring and place the 2 spring retainer locks around the valve stem.
![]() |
Using a plastic-faced hammer and 5 mm pin punch, lightly tap the valve stem tip to ensure a proper fit.
| 6. INSTALL EXHAUST VALVE |
![]() |
Apply plenty of engine oil to the tip area of the exhaust valve shown in the illustration.
Install the valve, valve spring seat, compression spring and spring retainer to the cylinder head.
![]() |
Using SST, compress the compression spring and place the 2 spring retainer locks around the valve stem.
![]() |
Using a plastic-faced hammer and 5 mm pin punch, lightly tap the valve stem tip to ensure a proper fit.