Home › Vehicle Exterior › LIGHTING (EXT) › TURN SIGNAL FLASHER ASSEMBLY

TURN SIGNAL FLASHER ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL TURN SIGNAL FLASHER ASSEMBLY


    E161849
  1. Install the turn signal flasher with the nut.

  1. Connect the connector.



2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


B192333
  1. Engage the 2 claws and install the sensor.

  1. Connect the connectors.

  1. Engage the 4 clips and claw and install the finish panel.

  1. Install the 2 <A> bolts.



3. INSTALL INSTRUMENT SIDE PANEL LH


    B192332
  1. Engage the 4 guides and 3 claws and install the side panel.



4. INSTALL COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure as for the RH side .



5. INSTALL FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure as for the RH side .