Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM

WIPER AND WASHER SYSTEM > Washer Fluid Level Warning Switch Circuit

for Preparation Click here


DESCRIPTION

When the volume of washer fluid decreases to below a certain level (when the washer fluid level warning switch is turned ON), the combination meter assembly warns the driver through the master warning light illumination and the warning message on the multi-information display*1, or the washer warning light illumination*2.

HINT:
*1: w/ Multi-information Display
*2: w/o Multi-information Display


WIRING DIAGRAM


E146596E03


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (WASHER FLUID LEVEL WARNING SWITCH)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Combination Meter / Data List.

  1. According to the display on the Techstream, read the Data List.


Combination Meter 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Washer Switch
Washer fluid level warning switch / ON or OFF
ON: Washer jar and tank is empty
OFF: Washer jar and tank is full
-

OK:
On the Techstream screen, each item changes between ON and OFF according to above chart.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT WASHER FLUID LEVEL WARNING SWITCH ASSEMBLY


    E162511E02
  1. Disconnect the A31 washer fluid level warning switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (S) - 2 (E)
    Washer jar is empty
    Below 1 Ω
    Washer jar is full
    10 kΩ or higher

  1. Reconnect the washer fluid level warning switch connector.



NG
REPLACE WASHER FLUID LEVEL WARNING SWITCH ASSEMBLY
OK


3.CHECK HARNESS AND CONNECTOR (WASHER FLUID LEVEL WARNING SWITCH - COMBINATION METER)


    E146597E02
  1. Disconnect the A31 washer fluid level warning switch connector.

  1. Disconnect the H37 combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A31-1 (S) - H37-10 (WLVL)
    Always
    Below 1 Ω
    A31-1 (S) or H37-10 (WLVL) - Body ground
    Always
    10 kΩ or higher
    A31-2 (E) - Body ground
    Always
    Below 1 Ω

  1. Reconnect the washer fluid level warning switch connector.

  1. Reconnect the combination meter connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)