Home › Drivetrain ยท JF3A TRANSFER / 4WD / AWD › 4WD CONTROL ECU

4WD CONTROL ECU > INSTALLATION

for Preparation Click here



1. INSTALL 4WD CONTROL ECU


    C160016
  1. Install the ECU with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the 2 ECU connectors.



2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH


B192333
  1. Engage the 2 claws and install the sensor.

  1. Connect the connectors.

  1. Engage the 4 clips and claw and install the finish panel.

  1. Install the 2 <A> bolts.



3. INSTALL INSTRUMENT SIDE PANEL RH


B192333
  1. Engage the 2 claws and install the sensor.

  1. Connect the connectors.

  1. Engage the 4 clips and claw and install the finish panel.

  1. Install the 2 <A> bolts.



4. INSTALL COWL SIDE TRIM BOARD RH
  1. Install the cowl side trim board RH ().

    HINT:
    Use the same procedures described for the LH side.



5. INSTALL FRONT DOOR SCUFF PLATE RH
  1. Install the front door scuff plate RH ().

    HINT:
    Use the same procedures described for the LH side.