Home › Drivetrain ยท JF3A TRANSFER / 4WD / AWD › 4WD CONTROL ECU

4WD CONTROL ECU > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE RH
  1. Remove the front door scuff plate RH .

    HINT:
    Use the same procedures described for the LH side.



2. REMOVE COWL SIDE TRIM BOARD RH
  1. Remove the front door scuff plate RH .

    HINT:
    Use the same procedures described for the LH side.



3. REMOVE INSTRUMENT SIDE PANEL RH


    B192331E01
  1. Apply protective tape, as shown in the illustration.

  1. Using a moulding remover, disengage the 3 claws and 4 guides and remove the side panel.



4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH


B192333
  1. Remove the 2 <A> bolts.

  1. Disengage the 4 clips and claw.

  1. Disengage the 2 claws and separate the sensor.

  1. Disconnect the connectors and remove the finish panel.



5. REMOVE 4WD CONTROL ECU


    C160016
  1. Disconnect the 2 4WD control ECU connectors.

  1. Remove the bolt and 4WD control ECU.