Home › Engine / Hybrid System ยท 3UR-FE › EMISSION CONTROL › AIR INJECTION DRIVER

AIR INJECTION DRIVER > REMOVAL

for Preparation Click here



1. REMOVE AIR INJECTION CONTROL DRIVER ASSEMBLY


A153551
  1. Disconnect the 4 air injection control driver connectors.



    A153552
  1. Remove the bolt and disconnect the ground cable.

  1. Disconnect the 2 wire harness clamps.



    A153553
  1. Remove the 3 bolts and air injection control driver.



2. REMOVE AIR INJECTION CONTROL DRIVER (for Bank 1)


A159760
  1. Remove the 2 bolts.



    A159761
  1. Remove the 2 screws and air injection control driver.



3. REMOVE AIR INJECTION CONTROL DRIVER (for Bank 2)


A159762
  1. Remove the 2 screws and air injection control driver.