Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF SYSTEM

SLIDING ROOF SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here



CUSTOMIZING FUNCTION WITH TECHSTREAM

HINT:
The following items can be customized.

NOTICE:
  1. When the customer requests a change in a function, first make sure that the function can be customized.
  2. Be sure to make a note of the current settings before customizing.
  3. When troubleshooting a function, first make sure that the function is set to the default setting.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream ON.

  4. Enter the following menus: Customize Setting.

  5. Select the setting by referring to the table below.

    Sliding Roof 
    Display (Item)
    Default
    Content
    Setting
    Door Key Related Operation
    SLIDE
    Function to select either tilt up or slide open for the manual sliding roof operation linked with power window, which is activated by holding the driver door key in the unlock position for 3 seconds or more when the ignition switch is off.
    Tilt/Slide
    Door Key Related Open
    ON
    Function to manually open the sliding roof linked with power window by holding the driver door key in the unlock position for 3 seconds or more when the ignition switch is off.
    ON/OFF
    Door Key Related Close
    ON
    Function to manually close the sliding roof linked with power window by holding the driver door key in the lock position for 3 seconds or more when ignition switch is off.
    ON/OFF