Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › CLEARANCE SONAR MAIN SWITCH

CLEARANCE SONAR MAIN SWITCH > INSPECTION

for Preparation Click here



1. INSPECT DRIVE MONITOR SWITCH


  1. Check the resistance.



      E147261E01
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      7 (IG) - 8 (SK)
      Sonar switch off
      10 kΩ or higher
      Sonar switch on
      Below 1 Ω

      If the result is not as specified, replace the drive monitor switch.

  1. Inspect the illumination operation.

    1. Connect the positive (+) lead to terminal 1 (ILL+) and the negative (-) lead to terminal 6 (ILL-), and then check that the illumination illuminates.

      OK:
      Illumination illuminates.

      If the result is not as specified, replace the drive monitor switch.