Home › Drivetrain ยท A750F AUTOMATIC TRANSMISSION / TRANSAXLE › OIL PUMP

OIL PUMP > INSTALLATION

for Preparation Click here



1. INSTALL OIL PUMP ASSEMBLY


    D028809E01
  1. Install the No. 1 thrust bearing race to the front oil pump.

    Thrust Bearing Race Diameter:
    Item
    Inside
    Outside
    Race
    74.2 mm (2.92 in.)
    87.74 mm (3.45 in.)



    D028796E02
  1. Coat a new O-ring with ATF, and install it around the oil pump assembly.

  1. Place the oil pump through the input shaft, and align the bolt holes of the oil pump assembly with the transmission case.

  1. Hold the input shaft, and lightly press the oil pump body to slide the oil seal rings into the overdrive direct clutch drum.

    NOTICE:
    Do not excessively push on the oil pump, as the oil seal ring will stick to the direct clutch drum.



    D027921E01
  1. Install the 10 bolts.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }



2. INSTALL AUTOMATIC TRANSMISSION HOUSING


    C159645E01
  1. Clean the threads of the bolts and case with non-residue solvent.

  1. Apply adhesive to the threads of the 4 bolts B and C.

    Adhesive:
    Toyota Genuine Adhesive 1344,
    Three Bond 1344 or equivalent

  1. Install the transmission housing with the 10 bolts.

    1. for 14 mm head bolt A

    Torque:
    34 N*m{ 345 kgf*cm , 25 ft.*lbf }

    1. for 17 mm head bolt B

    Torque:
    57 N*m{ 581 kgf*cm , 42 ft.*lbf }

    1. for 14 mm head bolt C

    Torque:
    34 N*m{ 345 kgf*cm , 25 ft.*lbf }