Home › Engine / Hybrid System ยท 3UR-FBE › ENGINE CONTROL › POWER STEERING OIL PRESSURE SWITCH

POWER STEERING OIL PRESSURE SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT POWER STEERING OIL PRESSURE SWITCH
  1. Check the oil pressure switch.

    1. Connect the Techstream to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the Techstream main switch on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Power Steering Pressure.

    5. Start the engine.

    6. Operate the steering wheel while idling, and read the value on the Techstream.

      Standard:
      Condition
      Specified Condition
      Power steering not operating
      0 to 2 MPa
      Power steering operating
      Values change from above value

      If not as specified, check for DTCs (Click here). If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure switch.
      Inspect the power steering system (Click here). If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure switch.