MASS AIR FLOW METER > INSPECTION |
| 1. INSPECT MASS AIR FLOW METER |
Check the output voltage.
![]() |
Apply battery voltage across terminals 1 (+B) and 2 (E2G).
Using a voltmeter, connect the positive (+) tester probe to terminal 3 (VG), and negative (-) tester probe to terminal 2 (E2G).
Blow air into the MAF meter, and check that the voltage fluctuates.
If the result is not as specified, replace the MAF meter.
![]() |
Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter shown in the illustration.
Check the IAT sensor.

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 4 (THA) - 5 (E2) | -20°C (-4°F) | 12.5 k to 16.9 kΩ |
| 20°C (68°F) | 2.19 k to 2.67 kΩ | |
| 60°C (140°F) | 0.50 k to 0.68 kΩ |