Home › Engine / Hybrid System ยท 3UR-FE › ENGINE CONTROL › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE V-BANK COVER SUB-ASSEMBLY


A165576E03
  1. Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.



2. REMOVE AIR CLEANER HOSE ASSEMBLY


A187008
  1. Disconnect the vacuum hose and ventilation hose.

  1. Loosen the 2 clamps.

  1. Remove the air cleaner hose.



3. REMOVE CAMSHAFT POSITION SENSOR


A158617
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.



4. REMOVE VVT SENSOR


A158607E04
  1. Disconnect the 4 sensor connectors.

  1. Remove the 4 bolts and 4 sensors.