Home › Engine / Hybrid System · 3UR-FE › ENGINE CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK HEATED OXYGEN SENSOR
  1. Disconnect the 2 sensor connectors.



    A159234E06
  1. Measure the heater resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (HT1B) - 2 (+B)
    (for Bank 1)
    20°C (68°F)
    11 to 16 Ω
    1 (HT2B) - 2 (+B)
    (for Bank 2)

    If the result is not as specified, replace the sensor.

  1. Connect the 2 sensor connectors.