Home › Engine / Hybrid System ยท 3UR-FE › ENGINE CONTROL › SFI SYSTEM

DTC    P1607    Cruise Control Input Processor

for Preparation Click here


DESCRIPTION

The ECM continuously monitors its main and sub CPUs. This self-check ensures that the ECM is functioning properly. If outputs from the CPUs are different and deviate from the standard, the ECM will illuminate the MIL and store a DTC immediately.

DTC No.
DTC Detection Condition
Trouble Area
P1607
ECM CPUs malfunction
ECM

MONITOR STRATEGY


Related DTC
P1607: Internal control module range check
Required sensors/Components (main)
ECM
Required sensors/Components (sub)
Cruise control
Frequency of Operation
Continuous
Duration
0.3 seconds
MIL Operation
Immediate
Sequence of Operation
None

TYPICAL ENABLING CONDITIONS


Monitor runs whenever the following DTCs are not present
None
DMA communication error
Not detected

TYPICAL MALFUNCTION THRESHOLDS


Cruise control
Forbiddance
When either condition below is met:
-
  1. Cruise control
Operating
  1. Low speed control
Operating

INSPECTION PROCEDURE

1.CHECK DTC
  1. Clear DTC (Click here).

  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative battery terminal and wait for 1 minute.

  1. Connect the cable to the negative battery terminal.

  1. Turn the ignition switch to ON.

  1. Check DTC.

    OK:
    P1607 is not present.



NG
REPLACE ECM (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)