Home › Engine / Hybrid System ยท 2UZ-FE › ENGINE CONTROL › ECM

ECM > INSTALLATION

for Preparation Click here



1. INSTALL GASKET
  1. Clean the ECM seal's surface with non-residue solvent.

  1. Attach a new gasket to the ECM.



2. INSTALL ECM


    A155993
  1. Install the ECM with the 4 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

    NOTICE:
    1. Make sure the gasket is not folded or caught on any area on the surrounding part.
    2. Make sure there is no foreign matter caught between the gasket and surrounding part.
    3. Do not damage the gasket.



    A160064
  1. Connect the 2 ECM connectors and push each lock lever down to lock the 2 ECM connectors.

    NOTICE:
    1. Make sure that the lock lever is raised 90° before connecting the ECM connectors. Failure to do this may cause the lock lever and terminals to break.
    2. Do not twist the wire harness when connecting the ECM connectors.



    A185617
  1. Connect the wire harness clamp.



3. CONNECT CONNECTOR HOLDER BLOCK


    A155992
  1. Connect the connector holder block with the 3 bolts.

    Torque:
    7.3 N*m{ 74 kgf*cm , 65 in.*lbf }



4. INSTALL AIR CLEANER ASSEMBLY


A185616
  1. Install the air cleaner assembly with the 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the mass air flow meter connector and clamp.



5. INSTALL AIR CLEANER HOSE ASSEMBLY


    A153488E02
  1. Install the air cleaner hose assembly with the 2 clamps.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }

    HINT:
    Make sure that the clamp band end is aligned with the limit mark when the hose clamp is tightened, as indicated by A and B in the illustration.

  1. Connect the vacuum hose and No. 2 ventilation hose.



6. INSTALL THROTTLE BODY COVER SUB-ASSEMBLY


    A153486
  1. Install the throttle body cover sub-assembly with the 2 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).



8. PERFORM INITIALIZATION
  1. Perform initialization procedures (Click here).