Home › Engine / Hybrid System ยท 2UZ-FE › ENGINE CONTROL › ECM

ECM > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE THROTTLE BODY COVER SUB-ASSEMBLY


    A153486
  1. Remove the 2 nuts and throttle body cover sub-assembly.



3. REMOVE AIR CLEANER HOSE ASSEMBLY


    A153487
  1. Disconnect the vacuum hose and No. 2 ventilation hose.

  1. Loosen the 2 hose clamps and remove the air cleaner hose assembly.



4. REMOVE AIR CLEANER ASSEMBLY


    A185616
  1. Disconnect the clamp and mass air flow meter connector.

  1. Remove the 2 bolts and remove the air cleaner assembly.



5. DISCONNECT CONNECTOR HOLDER BLOCK


    A155992
  1. Remove the 3 bolts and disconnect the connector holder block.



6. REMOVE ECM


    A185617
  1. Disconnect the wire harness clamp.



    A167149E01
  1. Raise the 2 levers while pushing the locks on the 2 levers.

    NOTICE:
    A155994
    Make sure that the lock lever is raised 90° as shown in the illustration before disconnecting the connectors. Failure to do this may cause the connectors to break.

  1. Disconnect the 2 connectors.



    A155993
  1. Remove the 4 bolts and ECM.



7. REMOVE GASKET


    A167150
  1. Peel off the rubber part of the gasket.



    A167151
  1. Spray gasket remover or equivalent on the remaining tape of the gasket.

    NOTICE:
    When using gasket remover or equivalent, cover the ECM connector with a cloth.



    A167152
  1. Use a cutter knife to remove the tape of the gasket.

    NOTICE:
    Do not damage the ECM seal's surface with the knife.