Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL RECEIVER

DOOR CONTROL RECEIVER > REMOVAL

for Preparation Click here



1. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY


    B190118
  1. Raise the handle, disengage the 4 guides and remove the No. 2 deck board.



2. REMOVE LUGGAGE COMPARTMENT TRIM BOX


    B194633
  1. Remove the 4 caps.



    B190116
  1. Remove the 4 bolts and the luggage compartment trim box.



3. REMOVE ROPE HOOK ASSEMBLY


    B191405
  1. Remove the bolt and the rope hook.

    HINT:
    Use the same procedure for both sides.



4. REMOVE NO. 1 DECK BOARD SUB-ASSEMBLY


    B190117
  1. Disengage the 5 clips and remove the No. 1 deck board.



5. REMOVE DECK BOARD REINFORCEMENT SUB-ASSEMBLY


    B190120
  1. Remove the 4 bolts and the deck board reinforcement.



6. REMOVE DECK BOARD BRACKET


    B190119
  1. Remove the 2 bolts and the deck board bracket.



7. REMOVE REAR NO. 2 SEAT ASSEMBLY LH
  1. Remove the rear No. 2 seat assembly LH (Click here).



8. REMOVE REAR NO. 2 SEAT ASSEMBLY LH
  1. Remove the rear No. 2 seat assembly LH (Click here).



9. REMOVE REAR SEAT CUSHION HINGE LOWER COVER LH

HINT:
Use the same procedure for both sides.



10. REMOVE REAR FLOOR STEP NO. 1 COVER


    B191403E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the cap.

    HINT:
    Use the same procedure for both sides.



11. REMOVE REAR FLOOR STEP NO. 2 COVER


    B193052E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the cap.

    HINT:
    Use the same procedure for both sides.



12. REMOVE REAR DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.



13. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

HINT:
Use the same procedure for both sides.



14. REMOVE ROPE HOOK ASSEMBLY

HINT:
Use the same procedure for both sides.



    B190140E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the cover.



    B190141
  1. Remove the bolt and the rope hook.



15. REMOVE REAR FLOOR MAT SUPPORT PLATE


    B190142
  1. Disengage the 5 clips and the 4 claws and remove the rear floor mat support plate.



16. REMOVE QUARTER TRIM PANEL ASSEMBLY LH


    B193920
  1. Disengage the 3 claws and remove the outer lap belt anchor cover.



    B191818
  1. Remove the bolt and outer lap belt anchor.



    B191816
  1. Remove the bolt and outer lap belt anchor.



    B191817E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the cover.



  1. Remove the 2 bolts.


    B190144

  1. Disengage the 14 clips.

  1. Disconnect the connector and remove the quarter trim panel.



17. REMOVE QUARTER TRIM PANEL ASSEMBLY LH (for Power Seat)


    B193920
  1. Disengage the 3 claws and remove the outer lap belt anchor cover.



    B191818
  1. Remove the bolt and outer lap belt anchor.



    B191816
  1. Remove the bolt and outer lap belt anchor.



    B191817E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the cover.



  1. Remove the 2 bolts.


    B191800

  1. Disengage the 2 clamps and remove the wire harness.

  1. Disengage the 14 clips and 2 clamps.

  1. Disconnect the 3 connectors and remove the quarter trim panel.



18. REMOVE DOOR CONTROL RECEIVER
  1. Disconnect the connector.



    B192555
  1. Remove the bolt and remove the door control receiver.