FRONT BUMPER > DISASSEMBLY |
| 1. REMOVE FRONT BUMPER GARNISH |
![]() |
Remove the 6 clips.
Disengage the 5 claws and remove the front bumper garnish.
| 2. REMOVE FOG LIGHT COVER LH |
![]() |
Disengage the 6 claws and remove the fog light cover.
| 3. REMOVE FOG LIGHT COVER RH |
| 4. REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light) |
![]() |
Disengage the 2 claws and remove the fog light.
| 5. REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light) |
| 6. REMOVE NO. 1 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System) |
Disconnect the connector.
![]() |
While pushing down on the lever with a finger to release the claw, disengage the claw on the other side to remove the ultrasonic sensor.
| 7. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System) |
![]() |
Disengage the 2 claws and remove the ultrasonic sensor retainer from the front bumper.
| 8. REMOVE FRONT FENDER LINER BRACKET LH |
![]() |
Disengage the 2 claws and remove the front fender liner bracket.
| 9. REMOVE FRONT FENDER LINER BRACKET RH |
| 10. REMOVE CLIP |
![]() |
Remove the clip.
| 11. REMOVE FRONT BUMPER SIDE SUPPORT LH |
![]() |
Remove the 2 screws.
Disengage the 3 claws and remove the front bumper side support.
| 12. REMOVE FRONT BUMPER SIDE SUPPORT RH |
| 13. REMOVE FRONT UPPER CENTER BUMPER RETAINER |
![]() |
Remove the 6 nuts and front upper center bumper retainer.
| 14. REMOVE FRONT BUMPER END RETAINER LH |
![]() |
Remove the 3 nuts and front bumper end retainer.
| 15. REMOVE FRONT BUMPER END RETAINER RH |
| 16. REMOVE FRONT BUMPER REINFORCEMENT |
![]() |
Remove the 6 nuts and the front bumper reinforcement.
Disconnect the connectors.
| 17. REMOVE FRONT NO. 2 BUMPER EXTENSION SUB-ASSEMBLY LH |
![]() |
Remove the 4 nuts and the front No. 2 bumper extension.
| 18. REMOVE FRONT NO. 2 BUMPER EXTENSION SUB-ASSEMBLY RH |
| 19. REMOVE RADIATOR SIDE DEFLECTOR LH |
![]() |
Using a clip remover, remove the 6 clips and remove the radiator side deflector.
| 20. REMOVE RADIATOR SIDE DEFLECTOR RH (w/o Oil Cooler) |
| 21. REMOVE RADIATOR SUPPORT TO FRAME SEAL RH (w/ Oil Cooler) |
![]() |
Using a clip remover, remove the 2 clips and remove the radiator support to frame seal.