Home › Audio/Visual/Telematics › AUDIO / VIDEO › REAR SEAT ENTERTAINMENT SYSTEM

REAR SEAT ENTERTAINMENT SYSTEM > Sound Signal Circuit between Video Terminal and Television Display

for Preparation Click here


DESCRIPTION

This is the sound signal circuit from the video terminal to the television display assembly.

WIRING DIAGRAM


E145848E04


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - VIDEO TERMINAL)


    E145847E03
  1. Disconnect the U2 television display assembly connector.

  1. Disconnect the S5 video terminal connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    U2-24 (ADPG) - S5-8 (ADPG)
    Always
    Below 1 Ω
    U2-7 (R1+) - S5-2 (VAL+)
    U2-8 (L1+) - S5-1 (VAR+)
    U2-23 (SGND) - S5-3 (VA-)
    U2-24 (ADPG) - Body ground
    Always
    10 kΩ or higher
    U2-7 (R1+) - Body ground
    U2-8 (L1+) - Body ground
    U2-23 (SGND) - Body ground

  1. Reconnect the television display assembly connector.

  1. Reconnect the video terminal connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT VIDEO TERMINAL


    E150833E02
  1. Using an oscilloscope, check the waveform between each terminal and the body ground according to the conditions, as shown in the table below.

    OK: Waveform:
    Tester Connection
    Condition
    Specified Condition
    S5-1 (VAR+) - Body ground
    External device is playing, sound is being produced
    Waveform synchronized with sound is output
    S5-2 (VAL+) - Body ground



NG
REPLACE VIDEO TERMINAL
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)